OWNER'S MANUALMODEL NUMBER:PP1130ESSNOW THROWER Always Wear Eye Protection During OperationIMPORTANT MANUAL Do N
10TO CONTROL SNOW DISCHARGE (See Fig. 15)WARNING: Snow throwers have ex- posed rotating parts, which can cause severe injury from contact, or from ma-
11OPERATIONTO THROW SNOW (See Fig. 16)The auger rotation is controlled by the auger control lever located on the right side handle.• Squeeze auge
12TO ADJUST SKID PLATES (See Fig. 20)NOTE: The wrench provided in your parts bag may be used to adjust the skid plates.Skid plates are located on each
13OPERATIONCOLD START - ELECTRIC STARTER1. Insert safety ignition key into the ignition slot until it clicks. DO NOT turn the key. Keep the extra
14GENERAL REC OM MEN DA TIONSThe warranty on this snow thrower does not cover items that have been sub ject ed to operator abuse or negligence. To re
15MAINTENANCEAUGER GEAR CASE• The gear case was fi lled with lubricant to the proper level at the factory. The only time the lubricant needs attent
16CAUTION: Do not substitute. Use only original equip ment capscrew/shear bolts as sup plied with your snow thrower.4. Connect spark plug wire to s
17BELT KEEPERIDLER ARM SQUARE HOLEBOLTLOCK WASHERTRACTION DRIVE BELTCLUTCHING IDLER ARM BRACKETAUGER BELTFLAT WASHERAUGER PULLEYAUGERHOUSINGFRAMEENGIN
18SERVICE AND ADJUSTMENTSSTORAGEImmediately prepare your unit for storage at the end of the season or if the unit will not be used for 30 days or more
19Does not start 1. Fuel shut-off valve (if so 1. Turn fuel shut-off valve to OPEN position.
2IMPORTANTSafe Operation Practices for Walk-Behind Snow ThrowersThis snow thrower is capable of amputating hands and feet and throwing objects.Failure
LIMITED WARRANTYThe Manufacturer warrants to the original consumer purchaser that this product as manufactured is free from defects in materials and w
3CONGRATULATIONS on your purchase of a new snow thrower. It has been designed, engineered and man u fac tured to give best possible dependability and
4PARTS PACKED SEPARATELY IN CARTON
5Read these instructions and this man u al in its entirety before you attempt to assemble or operate your new snow thrower.Your new snow thrower has b
6ASSEMBLY / PRE-OPERATIONINSTALL TRACTION DRIVE CONTROL ROD(See Figs. 3 and 4)The traction drive control rod has the long loop on the end of the sprin
7INSTALL WEIGHT BAR (See Fig. 10)Though seldom required, the weight bar will re duce the ten den cy of the auger housing to ride up on hard, icy drift
8OPERATIONKNOW YOUR SNOW THROWERREAD THIS OWNER'S MANUAL AND ALL SAFETY RULES BEFORE OPERATING YOUR SNOW THROWER. Compare the illustrations with
9OPERATIONThrottle/engine control - used to se lect either FAST or SLOW engine speed and to STOP the engine.Traction drive control lever - used to eng
Comments to this Manuals