Poulan PPB1000E User Manual download pdf (Page 5)

STANDARDS: This edger attachment is Listed by Underwriter’s Laboratories, Inc., in ac-

cordance with UL Standard 1602, “Gasoline--Engine--Powered, Rigid--Cutting--Member,

Edgers and Edger Trimmers,” only when used with the following models:

31cc Powerhead (with trimmer attachment) PP036............................

31cc Powerhead (with trimmer attachment) PP136............................

ASSEMBLY

WARNING: If received assembled,

repeat all steps to ensure your unit is properly

assembled and all fasteners are secure.

Examine parts for damage. Do not use dam-

aged parts.

NOTE: If you need assistance or find parts

missing or damaged, call 1-800-554-6723.

TOOLS REQUIRED

S Hex wrench (provided)

HANDLEBAR ASSEMBLY

DANGER: RISK OF CUT. To avoid

serious injury, the barrier portion of the han-

dlebar must be installed as shown on the up-

per shaft of the powerhead to provide a barrier

between operator and the spinning blade. At-

tach handlebar mounting bracket above ar-

row on safety warning decal on the upper

shaft (powerhead end of unit). Ensure han-

dlebar is positioned on mounting bracket at

the end of the arrow on the handlebar decal.

NOTE: T wo mounting brackets are included

with this attachment. Both brackets are pro-

vided to adapt this attachment for use with pow-

erheads that have either a 1″ (2.5 cm) diamete r

or a 7/8″ (2.2 cm) diameter upper shaft. The

correct bracket must be used to ensure that the

handlebar is mounted securely to the upper

shaft before use.

Screw

Mounting

Bracket

Handlebar

Bracket Cover

1. Place the mounting bracket over the upper

shaft above the arrow on the safety label.

Be sure to use the correct mounting brack-

et for either the 1″ (2.5 cm) or 7/8″ (2.2 cm)

diameter upper shaft.

2. Position one of the bracket covers under

the upper shaft and align the mounting

bracket and the bracket cover screw

holes. Insert two screws into the screw

holes.

3. Secure the mounting bracket by tightening

the screws with the hex wrench.

4. Locate the decal on the handlebar. This

decal includes an arrow. Position the han-

dlebar with the mounting bracket at the

end of the arrow .

5. Position the second bracket cover over

the handlebar. Align the mounting bracket

and the bracket cover screw holes. Again

make sure the handlebar is at the end of

the arrow.

6. Insert two screws and hand tighten only.

Be sure the handlebar is installed cor-

rectly; then, tighten each screw securely

with the hex wrench.

1 2 3 4 5 6 7 8 9

Comments to this Manuals

No comments

Poulan PPB1000E User Manual Page 5

Comments to this Manuals

Related products and manuals for Gardening equipment Poulan PPB1000E