ASSEMBLY
UNPACK CARTON & INSTALL HANDLE (See
Fig. 2)
A
C AUl iON, Be careful of exposed staples
when handling or disposing of cartonirig
material.
IMPORTANT: WHEN UNPACKING AND ASSEMBLING
FILLER. BE CAREFUL NOT TO STRETCH OR KINK
SABLE(S).
' Cut cable ties securing handles.
• Slowly lift handle assembly up and align handle holes
with handle panel hole and slot.
» Loosely assemble hardware as shown. Be sure the
shorter (3/4" long) hex bolt is assembled in lower hole of
handle. Repeatfor opposite side. Tighten all hardware
securely.
• Cut cable ties securing tiller to skid and remove tiller
from skid.
INSTALL REVERSE ROD (See Fig. 2)
• Secure upper reverse rod to lower reverse rod using
clevis pin. Secure with cotter pin.
INSTALL DEPTH STAKE ASStWdLY
(See Fig. 3)
• Loosen nut “A”.
• Insert stake support between engine bracket halves with
stake spring down.
• Bolt stake support to engine brackets with bolts, lock
washers and nuts. Tighten securely. Tighten nut “A”.
• Depth stake must move freely. If it does not, loosen
support bolt.
HANDLE HEIGHT
• Handle height may be adjusted to better suit operator.
(See “HANDLE HEIGHT” in the Service and Adjust
ments section of this manual).
TILLING WIDTH
• Tilling width may be adjusted to better handle yourtilling
conditions (See “TINE ARRANGEMENT” in the Service
and Adjustments section of this manual).
TINE OPERATION
• Check tine operation before first use. (See “TINE
OPERATION CHECK” in the Service and Adjustments
section of this manual).
FIG. 2
Comments to this Manuals