Poulan 545137277 User Manual

ENGLISH ESPAÑOLFRANÇAISDANGER:Read and follow all Safety Rules and Operating Instructions beforeusing this product. Failure to do so can result in ser

10WARNING: Make sure the locking/release button is locked in the primary holeand the knob is securely tightened before op-erating the unit. Al l atta

11S During light duty cutting.S Near objects around which the line can wrapsuch as small posts, trees or fence wire.S For mowing or sweeping, use full

121. Clean the cover and the area around it tokeep dirt from falling into the carburetorchamber when the cover is removed.2. Remove parts by pressing

13SpoolCover11. Make sure the lines are not caught be-tween the rim of the spool and the wall ofthe cover .12. Reinstall the spool and cover onto thet

14STORAGEWARNING: Perform the followingsteps after each use:S Allow engine to cool before storing or trans-porting.S Store unit and fuel in a well ven

15TROUBLE CAUSE REMEDYEngine will notstart.1.ON/OFF switch inOFF position.2. Engine flooded.3. Fuel tank empty.4. Spark plug not firing.5. Fuel not re

16LIMITED WARRANTYPoulan PRO warrants to the original pur-chaser that each new Poulan PRO brandgasoline tool or attachment is free from de-fects in ma

17est authorized service center or call PoulanPRO at 1--800--554--6723. WARRANTY PE-RIOD: Any warranted part which is notscheduled for replacement as

2SAFETY RULESWARNING: When using gardeningappliances, basic safety precautions must al-ways be followed to reduce the risk of fire andserious injury.

3S Keep others away when making carburetoradjustments.S Use only recommended Poulan PROaccessories and replacement parts.S Have all maintenance and se

4S Always keep the wheel and depth adjustingskid in contact with the ground.S Always push the unit slowly over theground. Stay alert for uneven sidewa

5WARNING: Inspect the area to becultivated before starting the unit. Remove alldebris and hard and sharp objects such asrocks, vines, branches, rope,

6S Stop the unit immediately if you feel excessivevibration. Vibration is a sign of trouble. Inspectthoroughly for loose nuts, bolts or damagebefore c

7Coupler Primary HoleUpperShaftLocking/ReleaseButtonLowerAttachmentGuide RecessWARNING: Make sure the locking/release button is locked in the primary

8ON/OFF SWITCHThe ON/OFF switch is located on the triggerhandle and is used to stop the engine. Move theswitch to the OFF position to stop the engine.

9Primer BulbStart LeverStarter Handle5. Pull starter rope handle sharply until en-gine starts and runs.6. Allow unit to run for 10--15 seconds, thenfu