Poulan 2100 User Manual download pdf (Page 10)

F. BAR AND CHAIN OIL

• The Guide Bar and Cutting Chain require

continuous lubrication to remain in operat-

Lack of oil will quickly ruin the Bar and

Chain.

— Too little oil will cause overheating

shown

by smoke coming from the chain and/or discol

oration of the guide bar rails.

• Genuine POULAN orPOULANPRO Bar and

Chain Oil is reconunended to protect your

unit against excessive wear from heat and

friction.

POULAN or POULAN PRO oil resists

high temperature thinning. If POULAN or

POULAN PRO Bar and Cham Oil is not available,

use a good grade SAE 30 oiL Never use waste oil for

bar and chain lubrication.

• In freezing weather oil will thicken, mrfdng

it necessary to thin bar and chain oil with a

small nmniinfr. of #1 Diesel Fuel or kerosene.

Bar and rhлir^ oil must be free flowing for the oil

çj^tem to pump enough ofl for adequate lubrica

tion,

6. USE THE FOLLOWING:

30® or above — 100% lubricant — undiluted,

30®-0®F — 95% lubricant to 5% 01 Diesel Fuel or

kerosene.

Below 0®F — 90% lubricant to 10% 01 Diesel Fuel

or kerosene.

7. HOW TO FILL THE OIL TANK

a. Stop the engine.

b. Turn saw on its side with oil cap up. Figure 10 .

c. Loosen cap slowly and wait for pressure in the

tank to be released before removing the cap.

d. Fill the oü tank.

e. Replace the oil cap securely.

8. IMPORTANT POINTS TO

REMEMBER

Fill the oil tank each time you refrll the

foel tank

to ensure that there will be sufficient

oil for the chain whenever you start and run the

saw.

b. Keep sawdust and debris cleaned from

the oil holes in the guide bar

to allow an ad

equate oil flow to the oar and chain.

Keepspilledandi^attei^doilwipedfrom

the unit to avoid sawdust and debris

build-up.

Pby particular attention to oil on the

fan housmg and starter assembly to avoid over

heating the engine.

It is normal for a small amount of oil to

appear under the saw after the engine

st<^. This is excess oil draining from the bar

and chain when the saw is not in use.

NOTES

-10-

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 23 24

Comments to this Manuals

No comments

Poulan 2100 User Manual Page 10

Comments to this Manuals

Related products and manuals for Petrol tool Poulan 2100