Poulan 2100 User Manual download pdf (Page 13)

£ Remove di^, stones« loose bark, nails, sta

ples, and wire from the tree where cuts are

to be made.

/ g. Plan to stand on the up-hill side when cut-

V ting on a slope. Figure 14,

h. Plan a clear retre^ path to the rear and di

agonal to the line of fall. Figure 15 .

2. FELLING SMALL TREES--UESS THAN

6” IN DIAMETER

a. If you know the direction of fall:

1. ) Make a single felling cut on the side away from

the direction of fall.

2. ) Cut all the way through,

3. ) Stop the saw, put it down, and get away quickly

on your planned retreat path.

b. If you are not sure which way the tree will fall, use

the notch method described for felling large trees.

DONOTCITR A WARNING

—^near electrical wires or buildings,

—if you do not know the direction of tree falL

—at night since you will not be able to see well.

—during bad weather — rain, snow, strong

wind, etc.

3. FELLING LARGE TREES—6” IN DIAMETER

OR MORE

The notch method is used to fell large trees, A notch

is cut on the side of the tree in the desired direction of

faU. After a felling cut is made on the opposite side of

the tree, the tree will tend to fall into the notch,

NOTE: If the tree has large buttress roots, remove

them before making the notch. Cut into the but

tresses vertically, then horizontally. Figure 16 .

a. Make the notch cut. Figure 16 .

1. ) Cut the bottom of the notch first, throtigh 1/3

of the diameter of the tree,

2. ) Complete the notch by making the slant cut.

3. ) Remove the notch of wood.

Make the felling cut on the opposite side of the

notch about 2” higher than the bottom of the

notch.

Leave enough uncut wood between the felling cut

and the notch to form a hinge. Figure 17 .

NOTE: The hinge helps to keep the tree from twist

ing and falling in the wrong direction,

d. Use a wedge if there is any chance that the tree

will not fall in the desired direction.

A WARNING

Stay on the uphill side of the terrain to avoid in

jury hrom the tree rolling or sliding downhill af-

ter it is felled. Figure 15 .

_________________________

NOTE; Before the felling cut is complete, use wedges

to open the cut when necesseiry to control the direc

tion of fall. Use wood or plastic wed^s, but neozr

steel or iron, to avoid kickback and chain damage.

Be alert to signs that the tree is ready to fall:

1. ) Cracking sounds.

2. ) Widening of the Felling Cut,

3. ) Movement in the upper branches.

As tree starts to fall, stop the. sam, pvZ izdjown, and

gei away quickly on your plarmkd retreat path.

Be extremely cautious with partially fallen trees

that may be poorly supported, '^en a tree

doesn’t ^ completely, set the saw aside and pull

down the tree with a cable winch, block and

tackle, or tractor. To avoid injujy, do not cut down

a partially fallen tree with your saw.

)' Cut

4 Buttress

fr Roots

^ First

Direction

ХхАлмЬ

Stay On Uphill Side Of

Tree When Felling

F^^ure 14 Figure 15

DON’T PUT YOURSELF IN THESE POSITIONS

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 23 24

Comments to this Manuals

No comments

Poulan 2100 User Manual Page 13

Comments to this Manuals

Related products and manuals for Petrol tool Poulan 2100