Poulan 3300 User Manual download pdf (Page 7)

raEPARING YOUR SAMT FOR USE

A. GETTING READY

1. READ YOUR OPERATOR’S MANUAL

Your Operator’s Manual has been developed to help

you prepare your saw for use and to understand its

safe operation. It is important that you read your

manual completely to become familiar with the unit

before you begin assembly or attempt operation. Your

Poulan® Dealer is available to show you how to

operate your saw. Be sure to ask for his assistance.

2. HAVE THE FOLLOWING AVAILABLE:

Protective gloves

Approved, marked, fuel container.

Regular gasoline, leaded or unleaded.

Two-cycle engine oil. See “Fueling Your

Engine.’’

Bar and Chain Oil. See “Bar and Chain Lubri

cant.”

Scrench—ptwided with your saw. Use the long

end of the tool as a slotted screwdriver, the small

pipe end as a socket wrench, and the larger pipe

end to remove the spark plug.

Hex Wrench — provided with your saw for the

fan housing screws.

B. ATTACHING THE SPUR {OPTIONALI

The spur is a special piece of equipment designed

to assist the cutting operation. When assembled to

the saw, the spur will dig into the tree or log and:

-relieve contact pressure adding ease to the saw

ing operation.

- allow the saw to be more easily rotated or pivoted

into the cut.

To Install:

1. Remove bar clamp nuts and bar clamp.

2. Align the spur over the two holes on the bar clamp

side of the saw. Figure 6.

3. Insert the two screws and tighten evenly and sec

urely.

C. ATTACHING THE BAR AND CHAIN

I CAUTIONfl Wear protective gloves when handling

or operating your saw. The chain is sharp and can

cut you even when it is not moving!

A WARNING

Do not start engine without guide bar and chain

completely assembled. Otherwise, the clutch can

come off and serious injury can result.

e \bur saw Is equipped with a Reduced-Kickback

Guide Bar and a Low-Kickback Chain.

Use only the Reduced-Kickback Guide Bar and

Lo№Kickback Chain specified for your chain

saw model, when replacing these parts. See

“Specifications.”

1. Remove the bar clamp nuts and bar clamp if you

have not done so. Figure 6.

NOTE: Be sure lo remove the cardboard packing

over the bar studs and between the bar clamp

housing and the crankcase.

2. Turn the adjusting screw counterclockwise,

to move the adjusting pin almost as far as it will

go to the rear. Figure 9.

1 2 3 4 5 6 7 8 9 10 11 12 ... 23 24

Comments to this Manuals

No comments

Poulan 3300 User Manual Page 7

Comments to this Manuals

Related products and manuals for Petrol tool Poulan 3300