Poulan 115274026 User Manual download pdf (Page 10)

10

WARNING: Alternative fuels (not gas-

oline) such as E--15 (15% alcohol), E--20 (20%

alcohol), E--85 (85% alcohol) are NOT classified

as gasoline and are NOT approved for use in

2--stroke gasoline engines. Use of alternative

fuels will cause problems such as: improper

clutch engagements, overheating, vapor lock,

power loss, lubrication deficiency , deterioration

of fuel lines, gaskets and internal carburetor

components, etc. Alternative fuels cause high

moisture absorption into the fuel/oil mixture

lea di ng to oil and fuel separation.

HOW TO STOP YOUR UNIT

S Release the throttle trigger .

S Push and release the engine ON/STOP

swit ch. T h e swit ch wi l l aut o mat i ca l l y ret u rn to

the ON position. W ait 5 seconds before at-

tempting to restart unit to allow switch to reset.

ON/STOP

Switch

HOW TO S TART YOUR UNIT

WARNING: Avoid any contact with the

muffler . A hot muffler can cause serious burns.

Starting position

HELPFUL TIP

If your engine still does not

start after following these

instructions, please call

1--800--554--6723.

STARTING A COLD ENGINE

NOTE:

DO NOT squeeze the throttle trigger

until the engine has started and runs.

1. Set unit on a flat surface.

2. Slowly press the primer bulb 6 times.

3. Move the start lever to the START posi-

tion.

Primer Bulb

Start Lever

Starter Handle

4. Pull starter rope handle sharply until en-

gine starts and runs.

5. Allow unit to run for 10--15 seconds, then

fully squeeze the throttle trigger to disen-

gage the starting system.

STARTING A WARM ENGINE

1. Squeeze and hold the throttle trigger .

Keep throttle trigger fully squeezed until

engine runs smoothly ..

3. Pull starter rope sharply while squeezing

throttle trigger until engine runs.

NOTE: Normally, the warm starting proce-

dure can be used within 5--10 minutes after

the unit is turned off. If the unit sits for more

than 10 minutes without being ran, it will be

necessary to start the unit by following the

steps under STAR TING A COLD ENGINE or

following the starting instruction steps shown

on the unit.

STARTING A FLOODED ENGINE

Flooded engines can be started by placing

the start lever to the RUN position. Fully

squeeze throttle trigger . Pull the starter han-

dle repeatedly while squeezing throttle trigger

until engine starts and runs. This could re-

quire pulling the starter handle many times,

depending on how badly the unit is flooded.

If the unit still doesn’t start, refer to

TROUBLESHOOTING TABLE or call

1-800-554-6723.

OPERATING THE COUPLER

This model is equipped with a coupler which

enables optional attachments to be installed.

The optional attachments are:

MODEL:

Edger PP1000E.....................

Cultivator PP2000T..................

Blower PP3000B....................

Pruner PP5000P....................

Pruner PP5500P....................

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 20 21

Comments to this Manuals

No comments