Poulan 115274026 User Manual download pdf (Page 7)

7

30 inches

(76 cm)

CONFIGURING YOUR UNIT

You can configure your unit using a cutting head

for grass and light weeds, or a weed blade for

cutting grass, weeds, and brush up to 1/2 inch

(1 cm) in diameter . To assemble your unit, go to

the section for the desired configuration and fol-

low the instructions.

ASSEMBLY INFORMATION --

TRIMMER HEAD

TRIMMER

HEAD

NOTE:Remove the blade and metal shield be-

fore attaching the plastic shield and trimmer

hea d. To remove bl ade, align hole in the dust

cup with the hole in the side of the gearbox by

rotating the blade. Insert a small screwdriver

into aligned holes. This will ke ep the sha ft fr om

turning while loosening the blade nut. Remove

blade nut by turning clockwise. Remove the

screwdriver . Remove both washers and blade.

To remove metal shield, loosen and remove the

four mounting screws. See ATT ACHING THE

MET AL SHIELD and INSTALLA TION OF THE

MET AL BLADE for illustrations. Be sure to store

all parts and instructions for future use.

ATTA CHING THE PLASTIC SHIELD

ANDTRIMMERHEAD

WARNING: The shield must be prop-

erly installed. The shield provides partial

protection to the operator and others from the

risk of thrown objects, and is equipped with a

line limiter blade which cuts excess line to the

proper length. The line limiter blade (on un-

derside of shield) is sharp and can cut you.

1. Remove wing nut from shield.

2. Insert bracket into slot on shield.

3. Pivot shield until bolt passes through hole

in bracket.

4. Tighten the wing nut securely.

NOTE: If your unit has a plastic cover over

the threads on the threaded shaft, remove the

covering to expose the threads. Before instal-

ling the trimmer head, make sure the dust cup

and retaining washer are positioned on the

gearbox as shown below.

Wing Nut

Retaining Washer

Dust Cup

Bracket

Slot

Shield

Gearbox

NOTE: Make sure all parts are properly

installed as shown in the illustration before

installing the trimmer head.

5. Align hole in the dust cup with the hole in

the side of the gearbox by rotating the

dust cup.

6. Insert a small screwdriver into aligned

holes. This will keep the shaft from turn-

ing while tightening trimmer head.

Screwdriver

7. While holding the screwdriver in position,

thread trimmer head onto the shaft in the

direction shown on the decal (counter-

clockwise). Tighten until secure.

NOTE: The retaining washer must be posi-

tioned with the raised section facing toward the

gearbox.

ASSEMBLY INFORMATION -- WEED

BLADE

WEED

BLADE

NOTE: Remove the trimmer head and plastic

shield before attaching the metal shield and

installing the weed blade. To remove the trim-

mer head, align hole in the dust cup with the hole

in the side of the gearbox by rotating the dust

cup. In sert a small screwdri v er into aligned

1 2 3 4 5 6 7 8 9 10 11 12 ... 20 21

Comments to this Manuals

No comments